Witbox

aus Metalab Wiki, dem offenen Zentrum für meta-disziplinäre Magier und technisch-kreative Enthusiasten.
Zur Navigation springenZur Suche springen
Sprache: Deutsch
Subpages:
Witbox hat keine Unterseiten.


Witbox
Witbox.png
Eigentümer: Metalab
Status: Aktiv
Erfordert Einschulung: Ja
Erfordert Authentisierung: Ja
Kostet: 0.10 euro / gram
Hilfsbereite:



It is OK to use the printer as it is.

It is NOT OK to modify it in any way.

This is a consumer grade semi professional machine, if you want to tinker with a 3d-printer check out the mendel90 reprap.


Overview

Filament diameter 1.75mm

Layer height: 0.05-0.25 mm (0.2 is fast and looks good)

Material: PLA only

Firmware version: 1.4.2 ( 29.10.2015)

This machine was sponsored (better price) from 3dee.at

How to use it

Calibration (before every job @ metalab) - There is a calibration sheet inside the witbox. - Calibration is simple. Just follow the instructions on the menu. - Configuration -> Level plate

Load / Change Filament if neccessary - Careful not to entangle the filament!! - To cahnge or unload the filament select the matching option from the menu - very gently apply some pull to the filament and you will feel that the filament is actually pulled for extraction first and after some seconds it is ejected - Once the filament is eject apply some more pullign force - when the filament comes loose pull sharply and remove the filament from the tube completely (also any long debris that might hang off the filament needs to get out)


Save your .gcode to the SD card - Start cura - Import .stl - Save to SD - Done.

Start job from menu - Select "Print from SD" - Select your job - Push dialing wheel- > job starts



Wisdom Tables

These settings have been tested and worked fine.

MATERIAL Layer height Speed Temperature (°C) Who tried this Notes
PLA Neon Green 0.1mm 80mm/sec 210C overflo Good.
PLA WHITE (no name big spool) 0.1mm 80mm/sec 210C overflo Looks better at higher temperature
PLA Black bq 0.1mm 80mm/sec 210C overflo Good.
PLA transparent bq 0.1mm 80mm/sec 210C overflo Good.
PLA purple noname (3dee.at) 0.1mm 80mm/sec 210C overflo Good.


These settings caused some problems

MATERIAL Layer height Speed Temperature (°C) Who tried this Notes
WHAT? LAYER? SPEED TEMPERATURE you COMMENTS



Software

Cura for Witbox


Supporters


Diverse Links





TODOs

List of things we COULD do.

ANY MODIFICATION NEEDS CONSENS BEFORE BEING APPLIED!!! DO NOT CHANGE ANYTHING UNLESS WE ALL AGREE ON IT FIRST (jour fixe)


Setup raspberry pi with octoprint

Design camera mount

Mount camera

Add a white ledstrip

Add a switch to disable the ventilation