Metalock2.0

BETA!!! Running in Production since years

Currently BETA TESTING please leave all your experiences, ideas, bugreports, suggestions on the discussion page Diskussion:Metalock running since years quite good!

Metalock2.0

• is a custom built lock system and the successor of Metalock
• it consists of a DOCKSTAR embedded linux system, an EMZY sponsored by EVVA and an Arduino
• An Raspberry Pi for serving the Door Status as a Website

Door Status

Door Status is working again: Available in the local network over IPv4: http://10.20.30.77
Globally available over IPv6: http://[2a02:61:a2::d8]/

How

• Only Software of Door Status is on Github.

Lessons learned:
The Setup is not documented and quite complex.

Hardware documentation

• tbd (how is everything connected)
• Door Status is wired directly to the door status switch. Voltage divider is between the 2 connectors of the soor status Switch.

From 5V to 3V for the Raspberry Pi GPIO. 22K Ohm + 33K Ohm Resistors.

Software documentation
Metalock2.0

• TBD ;) (yeah right..) (pitfalls, config, buildprocess)
• IP: 10.20.30.20 (local IPv4 of DOCKSTAR)

Door Status:

• IP: 10.20.30.77 (local IPv4 of Raspberry Pi)
• Software of Doorstatus: https://github.com/Metalab/metadoor

Reference

• [http://www.digi.com/products/embeddedsolutions/
• OpenDuino Lock system

Who

• Overflo - Electronics + Arduino
• Amir - Sheevaplug Setup + Javaapp for serial communication

Doorstatus Software & Hardware:

• Brought to you by Nico, Nini, Ripper, Phileas, and many other lovely Metalab people <3
• Resurrected™ by Hetti

Videos

tbd

Photos

tbd

Future

We are planning to replace the whole System in the (near) future with an simpler and better setup. Metalock 3.0 - TBA -