Laser/Experiments: Unterschied zwischen den Versionen

aus Metalab, dem offenen Zentrum für meta-disziplinäre Magier und technisch-kreative Enthusiasten.
Wechseln zu: Navigation, Suche
(about)
(Eine dazwischenliegende Version des gleichen Benutzers werden nicht angezeigt)
Zeile 1: Zeile 1:
 
 
== about ==
 
== about ==
 
This section explores different possibilities of parameters and their outcome.
 
This section explores different possibilities of parameters and their outcome.
Zeile 14: Zeile 13:
 
** engraving a soap ended in the soap swelling,  or so I’ve heard.
 
** engraving a soap ended in the soap swelling,  or so I’ve heard.
  
 +
* Leather
 +
** Got a 1,5mm raw dark-brown leather, cutting goes incredible good, but on one side it goes better then on the other. Speed: 45, Power: 100, Freq.: 2500
 +
** Engraving is not soo good, you can see the engraved parts, but only on 100/100, and then its not even black or something... May this depends on your leather
  
 
== ideas ==
 
== ideas ==

Version vom 8. August 2011, 19:40 Uhr

about

This section explores different possibilities of parameters and their outcome. This is a good place to get you an idea on how to fine tune your parameters.

Material:

  • The material
    • different parameters 1
    • different parameters 2
    • different parameters 3
  • Soap
    • engraving a soap ended in the soap swelling, or so I’ve heard.
  • Leather
    • Got a 1,5mm raw dark-brown leather, cutting goes incredible good, but on one side it goes better then on the other. Speed: 45, Power: 100, Freq.: 2500
    • Engraving is not soo good, you can see the engraved parts, but only on 100/100, and then its not even black or something... May this depends on your leather

ideas

  • making a example raster / vector file for experimental cuts
    • using color mapping for different speed/power/frequency in one job..