Laser/Experiments: Unterschied zwischen den Versionen
aus Metalab Wiki, dem offenen Zentrum für meta-disziplinäre Magier und technisch-kreative Enthusiasten.
Zur Navigation springenZur Suche springenReox (Diskussion | Beiträge) (→about: added leather, new material) |
Chrysn (Diskussion | Beiträge) (lazzzored felt) |
||
(Eine dazwischenliegende Version von einem anderen Benutzer wird nicht angezeigt) | |||
Zeile 1: | Zeile 1: | ||
− | |||
== about == | == about == | ||
This section explores different possibilities of parameters and their outcome. | This section explores different possibilities of parameters and their outcome. | ||
Zeile 15: | Zeile 14: | ||
* Leather | * Leather | ||
− | ** Got a 1,5mm raw dark-brown leather, cutting goes incredible good, but on one side it goes better then on the other. Speed: | + | ** Got a 1,5mm raw dark-brown leather, cutting goes incredible good, but on one side it goes better then on the other. Speed: 45, Power: 100, Freq.: 2500 |
** Engraving is not soo good, you can see the engraved parts, but only on 100/100, and then its not even black or something... May this depends on your leather | ** Engraving is not soo good, you can see the engraved parts, but only on 100/100, and then its not even black or something... May this depends on your leather | ||
+ | |||
+ | * Thin felt ([http://www.creativehobbiesgroup.com/product/8436460 knorrprandel Bogen 1mm]) | ||
+ | ** Speed 100% | ||
+ | ** Power 10% | ||
+ | ** Pulse frequency 2500Hz | ||
== ideas == | == ideas == |
Version vom 1. Dezember 2012, 18:17 Uhr
about
This section explores different possibilities of parameters and their outcome. This is a good place to get you an idea on how to fine tune your parameters.
Material:
- The material
- different parameters 1
- different parameters 2
- different parameters 3
- Soap
- engraving a soap ended in the soap swelling, or so I’ve heard.
- Leather
- Got a 1,5mm raw dark-brown leather, cutting goes incredible good, but on one side it goes better then on the other. Speed: 45, Power: 100, Freq.: 2500
- Engraving is not soo good, you can see the engraved parts, but only on 100/100, and then its not even black or something... May this depends on your leather
- Thin felt (knorrprandel Bogen 1mm)
- Speed 100%
- Power 10%
- Pulse frequency 2500Hz
ideas
- making a example raster / vector file for experimental cuts
- using color mapping for different speed/power/frequency in one job..