Bandsaw: Unterschied zwischen den Versionen

aus Metalab Wiki, dem offenen Zentrum für meta-disziplinäre Magier und technisch-kreative Enthusiasten.
Zur Navigation springenZur Suche springen
Zeile 5: Zeile 5:
 
== Current Status ==
 
== Current Status ==
  
* REXON BS10: The green bandsaw.
+
<strike>* REXON BS10: The green bandsaw.
** 1.400 x 6,5 x 0,3 mm, 6 Zähne/Zoll
+
** 1.400 x 6,5 x 0,3 mm, 6 Zähne/Zoll</strike>
* Blue Saw: Operational, but band is a little bit rusty
+
* Bergin / Clarke CBS 355
 +
** See https://lists.metalab.at/pipermail/cnc/2014-May/000903.html
  
 
== How to Operate ==
 
== How to Operate ==

Version vom 8. September 2015, 17:58 Uhr

The Metalab currently has 2 different Bandsaws. Both Bandsaws are from Joe since 2014-05-01_Jour_Fixe.

A bandsaw can be used to cut wood, metalls and plastics not only in straight lines, but also curved lines.

Current Status

* REXON BS10: The green bandsaw.

How to Operate

  • Check if band is correctly tightned (Do it with caution, because the band is very sharp and can easily injure you!)
    • See Repair Guide otherwise...
  • Check if the band is OK
    • See Repair Guide otherwise..
  • Adjust the upper band holder to the correct hight (It should be right about your workpiece)
  • Switch it on
  • Saw

General Tips

  • Do not use the bedstop (Seitenanschlag), because the cut off piece can easily lock up there and press the band aside
  • A Bandsaw is a free-hand tool, mark you cut path and cut there instead of measuring on the machine
  • The band swings in every direction a few parts of a mm. Consider that while you are sawing!

How to Repair

There is a good guide how to correctly setup a bandsaw here: Bandsäge einstellen (German)