CNC-Fräse: Unterschied zwischen den Versionen

@@ Zeile 35: / Zeile 35: @@
 If you don't switch on the things in this particular order it can happen that the machine does things out of nowhere e.g. moves or turns on the spindle!!!
 === Start Up ===
-* Start CNC PC (dont turn on the G4 (The "G4 Case" stepper control thing), neither the FU)
+# Start CNC PC (do not turn on the G4 (The "G4 Case" stepper control thing), neither the VFD)
-* Start LinuxCNC
+# Start LinuxCNC
-* Check if the "Notaus" is physically triggered on the machine (Button is pressed)
+# Press the emergency stop at the machine frame (if not already pressed)
-* Now power on the G4
+# Power on the Stepper Driver (The G4 Case)
-* Now plug in the FU ("Frequenzumformer")
+# Plug in the Variable Frequency Drive (VFD)
-** Wait until the FU is booted
+## Wait until the VFD is started up
-** Check if 100.0 Hz is set on the screen of the FU
+## Check if 100.0 Hz is set on the screen of the VFD
-*** Otherwise rotate the rotary encoder that it is 100.0Hz
+## Otherwise rotate the rotary encoder that it is 100.0Hz
-* Now remove "Notaus" from the CNC
+# Now release emergency stop
-* Power on the Machine inside LinuxCNC
+# Power on the Machine inside LinuxCNC
-* Move near Homing position
+# Move near Homing position
-* Home the machine
+# Start Homing Sequence ("Referenzfahrt")
-* Warm up the Spindle as described here in the wiki
+# Warm up the Spindle as described here in the wiki
 Now the machine is ready to use.