CNC-Fräse: Unterschied zwischen den Versionen
Reox (Diskussion | Beiträge) adding real workpiece size |
Reox (Diskussion | Beiträge) |
||
| Zeile 33: | Zeile 33: | ||
There are some important steps to take, otherwise you can destroy everything - even the earth... | There are some important steps to take, otherwise you can destroy everything - even the earth... | ||
If you don't switch on the things in this particular order it can happen that the machine does things out of nowhere e.g. moves or turns on the spindle!!! | If you don't switch on the things in this particular order it can happen that the machine does things out of nowhere e.g. moves or turns on the spindle!!! | ||
=== Start Up === | |||
* Start CNC PC (dont turn on the G4 (The "G4 Case" stepper control thing), neither the FU) | * Start CNC PC (dont turn on the G4 (The "G4 Case" stepper control thing), neither the FU) | ||
* Start LinuxCNC | * Start LinuxCNC | ||
| Zeile 54: | Zeile 54: | ||
There is a sample code in the [[CNC-Fräse#GCode|GCode]] Section | There is a sample code in the [[CNC-Fräse#GCode|GCode]] Section | ||
=== Power Down === | |||
* Move Machine in a position where you can easily clean it and remove millheads | |||
* Press Emergency Stop | |||
* Plug out VFD | |||
* Shut down G4 | |||
* Exit LinuxCNC | |||
* Power off PC | |||
* Remove Millhead and Clamp | |||
* Clean the machine-bed and everything else. | |||
== Wie Spanne ich ein Werkzeug richtig ein == | == Wie Spanne ich ein Werkzeug richtig ein == | ||