CNC-Fräse: Unterschied zwischen den Versionen
Reox (Diskussion | Beiträge) Keine Bearbeitungszusammenfassung |
Reox (Diskussion | Beiträge) |
||
| Zeile 42: | Zeile 42: | ||
== Current Status== | == Current Status== | ||
* EMC is quite configured. Max-Movement speed is approx | * EMC is quite configured. Max-Movement speed is approx 2400 mm/min. Its a great device. | ||
** Consider not drive this fast anyway - 2200mm/min is currently a good setup without loosing steps | |||
* Homeing procedure in EMC is functional, and by that also soft-limits. Its now "nearly" impossible to move over some limits. Start EMC, turn machine on with f1/f2, press "home all", wait 30 sec. Than traverse to the wished zero of your working coordinate system, and touch off in all three axes. | * Homeing procedure in EMC is functional, and by that also soft-limits. Its now "nearly" impossible to move over some limits. Start EMC, turn machine on with f1/f2, press "home all", wait 30 sec. Than traverse to the wished zero of your working coordinate system, and touch off in all three axes. | ||
| Zeile 68: | Zeile 69: | ||
* buy some normal wood in reasonable size (40x100x1.8 cm) | * buy some normal wood in reasonable size (40x100x1.8 cm) | ||
* organize some aluminium for testing | * organize some aluminium for testing | ||
=== Ideas === | === Ideas === | ||