Laser/Experiments: Unterschied zwischen den Versionen
aus Metalab Wiki, dem offenen Zentrum für meta-disziplinäre Magier und technisch-kreative Enthusiasten.
Zur Navigation springenZur Suche springen (→about) |
Reox (Diskussion | Beiträge) (→about: added leather, new material) |
||
| Zeile 14: | Zeile 14: | ||
** engraving a soap ended in the soap swelling, or so I’ve heard. | ** engraving a soap ended in the soap swelling, or so I’ve heard. | ||
| + | * Leather | ||
| + | ** Got a 1,5mm raw dark-brown leather, cutting goes incredible good, but on one side it goes better then on the other. Speed: 100, Power: 60, Frequency:500Hz | ||
| + | ** Engraving is not soo good, you can see the engraved parts, but only on 100/100, and then its not even black or something... May this depends on your leather | ||
== ideas == | == ideas == | ||
Version vom 28. Juni 2011, 16:39 Uhr
about
This section explores different possibilities of parameters and their outcome. This is a good place to get you an idea on how to fine tune your parameters.
Material:
- The material
- different parameters 1
- different parameters 2
- different parameters 3
- Soap
- engraving a soap ended in the soap swelling, or so I’ve heard.
- Leather
- Got a 1,5mm raw dark-brown leather, cutting goes incredible good, but on one side it goes better then on the other. Speed: 100, Power: 60, Frequency:500Hz
- Engraving is not soo good, you can see the engraved parts, but only on 100/100, and then its not even black or something... May this depends on your leather
ideas
- making a example raster / vector file for experimental cuts
- using color mapping for different speed/power/frequency in one job..
