WhateverLab/Umbau: Unterschied zwischen den Versionen

@@ Zeile 49: / Zeile 49: @@
 === Electricity ===
-Ideally, we should subdivide the lab into at least 3 independant
+The WEL will be subdivided into 2 independent circuits wired from the fuse cabinet in the corner, one will serve power for the heavy machinery lab, and one for the remaining power and lights.
-circuits. The main reason for this is that short circuits are more
-likely to happen in an electronics lab than anywhere else. In
-addition, the future machine room will draw a lot of power, so it
-should have a dedicated circuit.
-We might be able to reuse some cable canals inside the walls. If not,
+All wiring will be done "aufputz", since the quality of the wiring inside the walls are questionable.
-we'll wire the circuits externally.
-A generous amount of outlets has to be provided for the work places
+Lighting should be neutral and bright and without too much flickering (e.g. neon with EVG).
-due to the amount of electronic apparatus being used.
-Lighting should be neutral and bright.
 == Phase 1 Tasks ==