Wizard23/USB EEG with Arduino HowTo: Unterschied zwischen den Versionen
aus Metalab Wiki, dem offenen Zentrum für meta-disziplinäre Magier und technisch-kreative Enthusiasten.
Zur Navigation springenZur Suche springen (→==) |
|||
| Zeile 30: | Zeile 30: | ||
#testen | #testen | ||
screen /dev/ttyUSB0 115200 | screen /dev/ttyUSB0 115200 | ||
| + | |||
| + | quitting: ctr A + K + Y | ||
# pinout remember help for marius usb programmarer | # pinout remember help for marius usb programmarer | ||
Aktuelle Version vom 17. Dezember 2007, 22:10 Uhr
this is just a writeup of some tricks I learned from User:MariusKintel
- installing avr gcc
sudo apt-get install gcc-avr avr-libc
- removing dmx drivers
sudo rmmod dmx_usb
- finding out how big a hex file is on the atmel
avr-size main.hex
- programming the bootloader
sudo make -f Makefile.usbasp DEVICE=atmega8 HEXFILE=ATmegaBOOT.hex
- flashing arduino
avrdude -F -p atmega8 -P /dev/ttyUSB1 -c stk500 -b 19200 -U flash:w:main.hex
- reading hex back
avrdude -F -p atmega8 -P /dev/ttyUSB0 -c stk500 -b 19200 -U flash:r:back.hex:i
anederungen hardware.h
==========
#define DDRB_INIT 0x2C // 0b00101100 #define PORTB_INIT 0x16 // 0b00010110 #define DDRC_INIT 0x00 // 0b00000000 #define PORTC_INIT 0x00 // 0b00000000 #define DDRD_INIT 0x02 // 0b00000010 #define PORTD_INIT 0x2f // 0b00101111
- testen
screen /dev/ttyUSB0 115200
quitting: ctr A + K + Y
- pinout remember help for marius usb programmarer
USB stecker
A T M E L
10pinheader
r b
e l
d u
e
10-to-6 stecker
r
e
d
6-to-6 fuer EEG
r b
e l
d a
c
k
