Bandsaw: Unterschied zwischen den Versionen

Version vom 24. Februar 2016, 21:14 Uhr

The Metalab currently has one operational Bandsaw. The Bandsaw is from Joe since 2014-05-01_Jour_Fixe.

A bandsaw can be used to cut wood, metalls and plastics not only in straight lines, but also curved lines.

REXON BS10: The green bandsaw. 1425mm x 6mm x 0,3 mm, 6 Zähne/Zoll (NO blade thicker than 0.5mm!)
- in Working condition, PLEASE consultate the manual before using!
- The Table is broken!!! Very light cuts only! This is potentially dangerous! You have been warned!
- Datei:BS10.pdf
Bergin / Clarke CBS 355: 1780mm +-3mm x 6mm, 6 TPI
NOT in working condition
- See https://lists.metalab.at/pipermail/cnc/2014-May/000903.html
- http://www.clarkeservice.co.uk/manuals/woodworker/cbs355.pdf

Check if band is correctly tightned (Do it with caution, because the band is very sharp and can easily injure you!)
- See Repair Guide otherwise...
Check if the band is OK
- See Repair Guide otherwise..
Adjust the upper band holder to the correct hight (It should be right about your workpiece)
Switch it on
Saw

Do not use the bedstop (Seitenanschlag), because the cut off piece can easily lock up there and press the band aside
A Bandsaw is a free-hand tool, mark you cut path and cut there instead of measuring on the machine
The band swings in every direction a few parts of a mm. Consider that while you are sawing!

There is a good guide how to correctly setup a bandsaw here: Bandsäge einstellen (German)

Blades:

@@ Zeile 7: / Zeile 7: @@
 * REXON BS10: The green bandsaw. 1425mm x 6mm x 0,3 mm, 6 Zähne/Zoll (NO blade thicker than 0.5mm!)
 ** in Working condition, PLEASE consultate the manual before using!
+** '''The Table is broken!!! Very light cuts only! This is potentially dangerous! You have been warned!'''
 ** [[Datei:BS10.pdf]]
 * Bergin / Clarke CBS 355: 1780mm +-3mm x 6mm, 6 TPI