CNC-Fräse: Unterschied zwischen den Versionen
Reox (Diskussion | Beiträge) |
Reox (Diskussion | Beiträge) |
||
| Zeile 288: | Zeile 288: | ||
To have cutting speed in m/min instead of mm/min you need to divide by 1000. | To have cutting speed in m/min instead of mm/min you need to divide by 1000. | ||
A third formular gives you an estimation how much cm³ you can remove per minute: <math>Q = a_e \cdot a_p \cdot v_f \cdot \frac{1}{1000}</math>. | A third formular gives you an estimation how much cm³ you can remove per minute: <math>Q = a_e \cdot a_p \cdot v_f \cdot \frac{1}{1000}</math>. | ||
The cutting speed in the datasheet of a cutter is often calculated for a service time ("Standzeit") of 1 hour. That means if you mill with the exact parameters that are posted in the datasheet, the cutter will be unuseable after about one hour. | |||
=How to= | =How to= | ||