Metaboard/2010 activities/Hacksession 2010-09-17: Unterschied zwischen den Versionen
aus Metalab Wiki, dem offenen Zentrum für meta-disziplinäre Magier und technisch-kreative Enthusiasten.
Zur Navigation springenZur Suche springenChrysn (Diskussion | Beiträge) (documentation about what happened today) |
Chrysn (Diskussion | Beiträge) (added picture) |
||
| Zeile 1: | Zeile 1: | ||
| + | [[image:Arduino flashes atmega.jpg|thumb|The ATmega168 is programmed by the Arduino, using three wires for MISO/MOSI/SCK, one for reset, and three LEDs for status indication. The green LED is used to show that the ATmega can run its own programs.]] | ||
* Received a short introduction to [[PCB CNC]] from [[user:bkubicek]] (?). | * Received a short introduction to [[PCB CNC]] from [[user:bkubicek]] (?). | ||
* Had a look at the [[Bauteilsortiment]] -- they have almost everything we need. notable exceptions are an rs485 serial driver and an RFM12 (there are three RFM12B, though; considering switching to 3.3V). | * Had a look at the [[Bauteilsortiment]] -- they have almost everything we need. notable exceptions are an rs485 serial driver and an RFM12 (there are three RFM12B, though; considering switching to 3.3V). | ||
Version vom 18. September 2010, 12:15 Uhr
- Received a short introduction to PCB CNC from user:bkubicek (?).
- Had a look at the Bauteilsortiment -- they have almost everything we need. notable exceptions are an rs485 serial driver and an RFM12 (there are three RFM12B, though; considering switching to 3.3V).
- Built a minimal programmer using an arduino and the layout from the ArduinoISP tutorial. Another tutorial was helpful too.
- Using this configuration, sketches can be uploaded to the second ATmega168 with the usual Makefiles (it helps to set the F_CPU correctly, though, otherwise the delay function produces slightly off results)
Next steps are uploading the V-USB bootloader to the ATmega and experimenting with USB HID; ordering missing components.
