TassimoHack

WTF?

• Do you often have problems getting up in the morning?

• Have you realized that aquiring more self-dicipline is simply too

hard?

• Have you tried placing the alarm clock at the other end of the

bedroom, just to find yourself bringing your pillow when turning it off and continue sleeping on the floor?

It's time to toss another technical solution at this: Wire the alarm clock to a coffee machine and wake up to a cup of fresh coffee within an arm's reach.

Tassimo Overview

Tassimo is an automatic and relatively small coffee machine. The retail price is ca. EUR 130, and it can be picked up at virtually any supermarket here in Wien.

Datei:Tassimo-orig.png

Tassimo

The Tassimo requires only two button presses to brew coffee once the machine has been prepared. A quick run-down of the preparations follows:

Preparation:

1. Turn machine OFF
2. Fill water tank
3. Insert coffee disc and close lid
4. Add cup
5. Turn machine ON -> standby LED will be on

Brew:

1. Press Start -> aufheizen LED will blink
2. Wait up to 1 minute while heating -> automatik LED will then turn on
3. Press Start -> Brewing will start, the automatik LED will blink
4. Wait while brewing. The automatik LED will turn off and the manuell LED will turn on when finished.

Cleanup:

1. Open lid and remove coffee

Tassimo Internals

Datei:Tassimo-open.png

Right cover disassembled

Datei:Tassimo-closeup.png

Internal circuit board

Interesting contact points on the Tassimo internal circuit board:

JP1, pin 1	5V
JP1, pin 3	standby
JP1, pin 7	automatik
JP1, pin 12	GND
SW1:	start/stop button

Alarm Clock Internals

FIXME: Unmodded Picture + buzzer picture + Oscilloscope picture

An alarm clock was chosen at random. Opening the clock revealed the buzzer connector. An oscilloscope was connected to analyze the signal: When the alarm is off, the signal stays constant at ca. 1.2 volts (battery power from an old, single-cell battery). When the alarm sounds, a waveform is present, with an amplitude reaching from ca. 0 volts to ca. 4 volts.

Circuit Design

Our I/O needs, based on the above dissections are:

• 1 (analog) input to sense the alarm
• 2 digital inputs to sense the standby and automatik LEDs
• 1 digital output to trigger the Start button

For this purpose, we decided to use a PIC12F675 in a 8-pin package. This microcontroller has an internal 4 MHz oscillator, 6 I/O ports and a built-in A/D converter for analog input purposes.

Eagle schematic

The circuit was then build and soldered onto a strip-board.

Eagle layout

Datei:Tassimo-stripboard.png

Finished circuit

Firmware

The firmware is quite simple. In essence, this is what should be done:

1. Wait until the alarm goes off (analog input raises above 3 volts)
2. Press Start button
3. Wait until the Automatik light goes off
4. Press Start button again

For simplicity of the toolchain, we decided to program the firmware in assembly.

FIXME: Assembly code, toolchain, programmin (PICkikt2)

Installation

Datei:Tassimo-installed.png

Installed circuit

To avoid having wires stick out of the Tassimo and make the alarm clock optional, a small input port was attached on the back side of the machine. The two pins are ground and alarm signal.

Datei:Tassimo-port.png

Alarm input port