Salami Rocket: Unterschied zwischen den Versionen

aus Metalab Wiki, dem offenen Zentrum für meta-disziplinäre Magier und technisch-kreative Enthusiasten.
Zur Navigation springenZur Suche springen
Zeile 41: Zeile 41:
  
 
== Injector ==
 
== Injector ==
Probably custom made. Basically a shower head ;).
+
Probably custom made or this one -> [http://www.rocketstore.co.uk/shop/product.asp?numRecordPosition=13&P_ID=1013&strPageHistory=man&strKeywords=&SearchFor=&PT_ID=0 SKR-54UC]
 +
* Diameter: 54mm
 +
* Price: 53 €
  
 
== Combustion Chamber ==
 
== Combustion Chamber ==

Version vom 16. Juni 2009, 20:16 Uhr

WTF?

Hybrid rocket propulsion system conceptual overview

Nomen est omen. Salami rocket is about building a hybrid rocket with a gaseous oxydizer and salami as propellants.

Oxydizer

I'd prefer N2O over 02 because although N2O carries a lot of conjectural inert nitrogen (64%) oxygen is much harder to handle (tank filling, storage & injection). Additionally the nitrogen, though not participating in combustion, raises the fuel erosion rate and cooles the nozzle enough to reuse it many times.

Fuel

Salami: High efficency hydrocarbon based fuel ;)

Draft

  • Run Tank: A light-weight container for the oxydizer capable of sustaining enough pressure
  • On/Off Valve: Enables/Disables oxydizer flow.
  • Throttle valve: A valve to allow precise regulation of the oxydizer flow from the run tank to the combustion chamber.
  • Injector: Aids in vaporizing the (still) liquid oxydizery.
  • Combustion Chamber: Where the oxydizer/fuel mix burns. Additionally to pressure (same amount as for the run tank) it has to sustain heat.
  • Nozzle: An opening that dramatically accelerates the hot gas escaping the combustion chamber.
  • Ignitor: Preheating the fuel and initializing combustion.
  • Shell: Protecting the motor
  • Recovery System: Enables slow decent after burn-out for safety and reusability

Shopping list

All parts directly participating in the combustion would have to sustain at least 51 bar (vapor pressure of N20 at 20°C) but for reasons of safety i assume 100bar as the minimum.

Run Tank

Smart Parts C02 aluminium tank for paintball guns with on/off valve.

  • Capacity: 591ml (20 oz)
  • Connector: 1,27cm (1/2")
  • Max Pressure: 200bar
  • Price: 45€

On/Off Valve

No separate valve needed since the proposed CO2 tank has it built-in.

Throttle valve

An adjustable throttle valve (Stasto VRB-030) intended for use in hydraulics.

  • Connector: 1,27cm (1/2")
  • Flow rate: 45 l/min
  • Working pressure: 350 bar
  • Price: 30€

Injector

Probably custom made or this one -> SKR-54UC

  • Diameter: 54mm
  • Price: 53 €

Combustion Chamber

C02 aluminium tank for paintball guns without on/off valve.

  • Capacity: 591ml (20 oz)
  • Connector: 1,27cm (1/2")
  • Max Pressure: 200bar
  • Price: 14€

Nozzle

SKR-54NZL graphite nozzle

  • Diameter: 54mm
  • Price: €35

Ignitor

None selected yet.

Shell

A nice design proposal by mactux. Exact specifications & blue prints yet to be made.

Recover System

None specified/selected yet.


Links