Metalock2.0: Unterschied zwischen den Versionen

aus Metalab, dem offenen Zentrum für meta-disziplinäre Magier und technisch-kreative Enthusiasten.
Wechseln zu: Navigation, Suche
(Metalock2.0)
Zeile 15: Zeile 15:
  
 
== How ==
 
== How ==
* Only Software of Door Status is on Github: https://github.com/Metalab/metadoor
+
* Only Software of Door Status is on Github.
  
 
Lessons learned: <br>
 
Lessons learned: <br>
Zeile 22: Zeile 22:
 
Hardware documentation
 
Hardware documentation
 
* tbd (how is everything connected)
 
* tbd (how is everything connected)
 +
* Door Status is wired directly to the door status switch. Voltage divider is between the 2 connectors of the soor status Switch.
 +
From 5V to 3V for the Raspberry Pi GPIO. 22K Ohm + 33K Ohm Resistors.
  
Software documentation
+
Software documentation <br>
 +
<b>Metalock2.0</b>
 
* TBD ;) (yeah right..) (pitfalls, config, buildprocess)
 
* TBD ;) (yeah right..) (pitfalls, config, buildprocess)
* IP: 10.20.30.77 (local IPv4 of DOCKSTAR)
+
* IP: 10.20.30.20 (local IPv4 of DOCKSTAR)
 +
 
 +
<b>Door Status:</b>
 +
* IP: 10.20.30.77 (local IPv4 of Raspberry Pi)
 +
* Software of Doorstatus: https://github.com/Metalab/metadoor
  
 
== Reference ==
 
== Reference ==

Version vom 13. Juli 2018, 23:29 Uhr

BETA!!! Running in Production since years

Currently BETA TESTING please leave all your experiences, ideas, bugreports, suggestions on the discussion page Diskussion:Metalock running since years quite good!

Metalock2.0

  • is a custom built lock system and the successor of Metalock
  • it consists of a DOCKSTAR embedded linux system, an EMZY sponsored by EVVA and an Arduino
  • An Raspberry Pi for serving the Door Status as a Website

Door Status

Door Status is working again: Available in the local network over IPv4: http://10.20.30.77
Globally available over IPv6: http://[2a02:61:a2::d8]/

How

  • Only Software of Door Status is on Github.

Lessons learned:
The Setup is not documented and quite complex.

Hardware documentation

  • tbd (how is everything connected)
  • Door Status is wired directly to the door status switch. Voltage divider is between the 2 connectors of the soor status Switch.

From 5V to 3V for the Raspberry Pi GPIO. 22K Ohm + 33K Ohm Resistors.

Software documentation
Metalock2.0

  • TBD ;) (yeah right..) (pitfalls, config, buildprocess)
  • IP: 10.20.30.20 (local IPv4 of DOCKSTAR)

Door Status:

Reference

Who

  • Overflo - Electronics + Arduino
  • Amir - Sheevaplug Setup + Javaapp for serial communication

Doorstatus Software & Hardware:

  • Brought to you by Nico, Nini, Ripper, Phileas, and many other lovely Metalab people <3
  • Resurrected™ by Hetti

Videos

tbd

Photos

tbd

Future

We are planning to replace the whole System in the (near) future with an simpler and better setup. Metalock 3.0 - TBA -