Laser/Experiments: Unterschied zwischen den Versionen
aus Metalab Wiki, dem offenen Zentrum für meta-disziplinäre Magier und technisch-kreative Enthusiasten.
Zur Navigation springenZur Suche springen (Die Seite wurde neu angelegt: „ == about == this page is about exploring various lazzzor settings for varying materials to get the most out of it Category:Dokumentation [[Category:Lazzzor]…“) |
Reox (Diskussion | Beiträge) |
||
(3 dazwischenliegende Versionen von 2 Benutzern werden nicht angezeigt) | |||
Zeile 1: | Zeile 1: | ||
+ | == about == | ||
+ | This section explores different possibilities of parameters and their outcome. | ||
+ | This is a good place to get you an idea on how to fine tune your parameters. | ||
+ | |||
+ | Material: | ||
+ | |||
+ | * The material | ||
+ | ** different parameters 1 | ||
+ | ** different parameters 2 | ||
+ | ** different parameters 3 | ||
+ | |||
+ | * Soap | ||
+ | ** engraving a soap ended in the soap swelling, or so I’ve heard. | ||
+ | |||
+ | * Leather | ||
+ | ** Got a 1,5mm raw dark-brown leather, cutting goes incredible good, but on one side it goes better then on the other. Speed: 45, Power: 100, Freq.: 2500 | ||
+ | ** Engraving is not soo good, you can see the engraved parts, but only on 100/100, and then its not even black or something... May this depends on your leather | ||
+ | |||
+ | == ideas == | ||
+ | * making a example raster / vector file for experimental cuts | ||
+ | ** using color mapping for different speed/power/frequency in one job.. | ||
− | |||
− | |||
[[Category:Dokumentation]] | [[Category:Dokumentation]] | ||
[[Category:Lazzzor]] | [[Category:Lazzzor]] | ||
[[Category:English]] | [[Category:English]] |
Version vom 8. August 2011, 17:40 Uhr
about
This section explores different possibilities of parameters and their outcome. This is a good place to get you an idea on how to fine tune your parameters.
Material:
- The material
- different parameters 1
- different parameters 2
- different parameters 3
- Soap
- engraving a soap ended in the soap swelling, or so I’ve heard.
- Leather
- Got a 1,5mm raw dark-brown leather, cutting goes incredible good, but on one side it goes better then on the other. Speed: 45, Power: 100, Freq.: 2500
- Engraving is not soo good, you can see the engraved parts, but only on 100/100, and then its not even black or something... May this depends on your leather
ideas
- making a example raster / vector file for experimental cuts
- using color mapping for different speed/power/frequency in one job..