Laser/Experiments: Unterschied zwischen den Versionen

aus Metalab Wiki, dem offenen Zentrum für meta-disziplinäre Magier und technisch-kreative Enthusiasten.
Zur Navigation springenZur Suche springen
(current curring value for leather)
(6 dazwischenliegende Versionen von 4 Benutzern werden nicht angezeigt)
Zeile 1: Zeile 1:
 
 
== about ==
 
== about ==
 
This section explores different possibilities of parameters and their outcome.
 
This section explores different possibilities of parameters and their outcome.
Zeile 14: Zeile 13:
 
** engraving a soap ended in the soap swelling,  or so I’ve heard.
 
** engraving a soap ended in the soap swelling,  or so I’ve heard.
  
[[Category:Dokumentation]]
+
* Leather
[[Category:Lazzzor]]
+
** Got a 1,5mm raw dark-brown leather, cutting goes incredibly well, but on one side it goes better then on the other. Speed: 45 or 40, Power: 100, Freq.: 2500
[[Category:English]]
+
** Engraving is not soo good, you can see the engraved parts, but only on 100/100, and then its not even black or something... May this depends on your leather
 +
 
 +
* Thin felt ([http://www.creativehobbiesgroup.com/product/8436460 knorrprandel Bogen 1mm])
 +
** Speed 100%
 +
** Power 10%
 +
** Pulse frequency 2500Hz
 +
 
 +
== ideas ==
 +
* making a example raster / vector file for experimental cuts
 +
** using color mapping for different speed/power/frequency in one job..
 +
 
 +
[[Kategorie:English]]
 +
[[Kategorie:Lazzzor]]

Version vom 19. Juni 2013, 23:52 Uhr

about

This section explores different possibilities of parameters and their outcome. This is a good place to get you an idea on how to fine tune your parameters.

Material:

  • The material
    • different parameters 1
    • different parameters 2
    • different parameters 3
  • Soap
    • engraving a soap ended in the soap swelling, or so I’ve heard.
  • Leather
    • Got a 1,5mm raw dark-brown leather, cutting goes incredibly well, but on one side it goes better then on the other. Speed: 45 or 40, Power: 100, Freq.: 2500
    • Engraving is not soo good, you can see the engraved parts, but only on 100/100, and then its not even black or something... May this depends on your leather

ideas

  • making a example raster / vector file for experimental cuts
    • using color mapping for different speed/power/frequency in one job..