Laser/Experiments: Unterschied zwischen den Versionen
aus Metalab Wiki, dem offenen Zentrum für meta-disziplinäre Magier und technisch-kreative Enthusiasten.
Zur Navigation springenZur Suche springen (→about) |
|||
| (4 dazwischenliegende Versionen von 3 Benutzern werden nicht angezeigt) | |||
| Zeile 1: | Zeile 1: | ||
| − | |||
== about == | == about == | ||
This section explores different possibilities of parameters and their outcome. | This section explores different possibilities of parameters and their outcome. | ||
| Zeile 14: | Zeile 13: | ||
** engraving a soap ended in the soap swelling, or so I’ve heard. | ** engraving a soap ended in the soap swelling, or so I’ve heard. | ||
| + | * Leather | ||
| + | ** Got a 1,5mm raw dark-brown leather, cutting goes incredible good, but on one side it goes better then on the other. Speed: 45, Power: 100, Freq.: 2500 | ||
| + | ** Engraving is not soo good, you can see the engraved parts, but only on 100/100, and then its not even black or something... May this depends on your leather | ||
| + | |||
| + | * Thin felt ([http://www.creativehobbiesgroup.com/product/8436460 knorrprandel Bogen 1mm]) | ||
| + | ** Speed 100% | ||
| + | ** Power 10% | ||
| + | ** Pulse frequency 2500Hz | ||
== ideas == | == ideas == | ||
| Zeile 19: | Zeile 26: | ||
** using color mapping for different speed/power/frequency in one job.. | ** using color mapping for different speed/power/frequency in one job.. | ||
| − | |||
| − | |||
[[Category:Lazzzor]] | [[Category:Lazzzor]] | ||
[[Category:English]] | [[Category:English]] | ||
Version vom 27. Januar 2013, 02:17 Uhr
about
This section explores different possibilities of parameters and their outcome. This is a good place to get you an idea on how to fine tune your parameters.
Material:
- The material
- different parameters 1
- different parameters 2
- different parameters 3
- Soap
- engraving a soap ended in the soap swelling, or so I’ve heard.
- Leather
- Got a 1,5mm raw dark-brown leather, cutting goes incredible good, but on one side it goes better then on the other. Speed: 45, Power: 100, Freq.: 2500
- Engraving is not soo good, you can see the engraved parts, but only on 100/100, and then its not even black or something... May this depends on your leather
- Thin felt (knorrprandel Bogen 1mm)
- Speed 100%
- Power 10%
- Pulse frequency 2500Hz
ideas
- making a example raster / vector file for experimental cuts
- using color mapping for different speed/power/frequency in one job..
