Iris

aus Metalab Wiki, dem offenen Zentrum für meta-disziplinäre Magier und technisch-kreative Enthusiasten.
Version vom 28. September 2010, 16:02 Uhr von Metaz (Diskussion | Beiträge)
(Unterschied) ← Nächstältere Version | Aktuelle Version (Unterschied) | Nächstjüngere Version → (Unterschied)
Zur Navigation springenZur Suche springen

The IRIS project

  • is an automated welcoming system
  • consists of an arduino, a waveshield, some lasercutted parts, a digital photoframe, a stepper motor, a stepper motor controller board

every time a visitor rings the door bell the uv light is turned on, the shiney plexi parts start to glow and the iris opens.

then the backlight of the fotoframe is turned on and the visitor sees whatever video is currently displayed (can not be controlled)

a short welcoming audio sample is played over the waveshield and after ~15 seconds the iris closes again and the backlight is turned off


Initalization

as the photoframe would not start videos from the SDcard automatically the enclosure of the fotoframe was opened and the buttons needed to e pressed to start a video where bound to pins on the arduino using optocouplers from the Bauteilsortiment.

when the machine is turned on it opens the iris slowly till it hits the endstop refernce point. (minidipswitch).


after a timeout of ~15 seconds the photoframe has booted and the microcontroller pushes the buttons to navigate triugh the menu and start the first found video on the SD card ENTER,ENTER,LEFT,LEFT,LEFT,ENTER,ENTER :)

then we turn off the background light (MOSFET) and close the iris (we are still at the endstop position)

from there it takes 140 steps in the other direction to close the iris again.




Who

  • Overflo - electronics, soldering, building, software
  • Wizard23 - help with qCAD

Files

Link to the .DXF for the .DXF layout of the iris: Datei:Iris final.dxf

this file is released under Attribution - Non-Commercial - Creative Commons license

Videos


Photos

Closed and relaxed
Armed
Welcome!
Backside


Links


TODOs

  • New welcome video
  • more "hello" wav samples
  • add motion sensor (ultrasonic) to trigger the welcome sequence, too many people ring the doorbell to see this ;)