HSC2011/Enclosure: Unterschied zwischen den Versionen

Aktuelle Version vom 4. Mai 2011, 04:47 Uhr

The enclosure was designed and manufactured by mazzo using Blender and our makerbot "le giraffe"

All up to date files are found in the GIT repository here is short summary of the important files
- Gcode and STL files to feed your 3D printer omnomnomnom
- The middlepart for the lazzor You should cut this from 6mm acryl
- Blender file


The bottom of the EduBuzzer enclosure	The top of the EduBuzzer enclosure
The complete EduBuzzer enclosure	Highlighted Battery holder, on/off switch holder and PCB


The enclosure + PCB	The bottom half of the enclosure
Fully assembled!	The middlepart is lazzored and the RGB led shines in there to change the color of the enclosure
middlepart attched to the enclosure	connection on the bottom for the iButton, on/off switch + power
bottompart + middlepart + pcb

@@ Zeile 54: / Zeile 54: @@
 |-
 | valign="top"|[[Bild:Enclosure_rgb_inlay.JPG|thumb|400px|left|bottompart + middlepart + pcb ]]
 |}
+==Blender Animation of the enclosure==
+{{#ev:youtube|i9sB169s1X8}}