CNC/FreeCAD: Unterschied zwischen den Versionen

aus Metalab Wiki, dem offenen Zentrum für meta-disziplinäre Magier und technisch-kreative Enthusiasten.
Zur Navigation springenZur Suche springen
(more interesting things)
Zeile 10: Zeile 10:
 
* The Path dressup tools are not in the normal toolbar. You have to go to Path --> Path Dressup in the menu bar!
 
* The Path dressup tools are not in the normal toolbar. You have to go to Path --> Path Dressup in the menu bar!
 
* When using holding tags, the postprocessor switches to vertical feed rate! be aware of that.
 
* When using holding tags, the postprocessor switches to vertical feed rate! be aware of that.
 +
* You can reorder operations in the CAM Module by double clicking on the Stock and go to the Workplan tab

Version vom 9. Oktober 2017, 16:12 Uhr

FreeCAD is a nice piece of software, but it is in development and there are many nasty bugs!

Here are some hints for using FreeCAD with the CNC:

  • Use at least version 0.17 (even if it is in development!). There are daily builds, use those!
  • Go to Preferences --> General --> Units and choose "Metric Small Parts & CNC". It will use mm/min instead of mm/s which is a huge improvement
  • Beware of bugs in the Path Module. There are tons of errors related to edge cases in trigonometry. So if you see something crazy, just change the numbers slightly helps sometimes.
  • Check the forum: https://forum.freecadweb.org and also report bugs you find, if they are not already reported
  • Before you mill something, test it extensivly in the LinuxCNC Simulator!!! The Path module might generate code which is not useable, as the module itself is not stable.
  • The Path dressup tools are not in the normal toolbar. You have to go to Path --> Path Dressup in the menu bar!
  • When using holding tags, the postprocessor switches to vertical feed rate! be aware of that.
  • You can reorder operations in the CAM Module by double clicking on the Stock and go to the Workplan tab