Blinkenwall.com/Controller: Unterschied zwischen den Versionen

aus Metalab Wiki, dem offenen Zentrum für meta-disziplinäre Magier und technisch-kreative Enthusiasten.
Zur Navigation springenZur Suche springen
K
K (linx)
Zeile 52: Zeile 52:
 
|}
 
|}
  
The transceiver is used so that you can put the display data pins and he buttons on the same GPIOs. It's a 74F245. The display is a HDM16216L-5-LCEP.
+
The transceiver is used so that you can put the display data pins and he buttons on the same GPIOs. It's a [https://www.ti.com/lit/ds/snos177a/snos177a.pdf 74F245]. The display is a [https://www.mouser.com/ds/2/178/16216l5-16494.pdf HDM16216L-5-LCEP].
  
 
The voltage is 5V for everything, except for the buttons. These simply pull to GND.
 
The voltage is 5V for everything, except for the buttons. These simply pull to GND.

Version vom 4. März 2017, 23:04 Uhr

Language: English
Subpages:
Blinkenwall.com/Controller hat keine Unterseiten.

Blinkenwall Controller

Case is from a Sun Cobalt RaQ 550.

Front Panel

The front panel has the following connector:

Raq 550 Pinout
Function Pin Pin Function
Display Enable 1 2 Transceiver !OE
GND 3 4 +5V
Display D1 5 6 Display D0
Display D3, Button Up 7 8 Display D2, Button Left
Display D5, Button Right 9 10 Display D4, Button Down
Display D7, Button S 11 12 Display D6, Button E
Display RS 13 14 Display R/W
GND 15 16 +5V
LED Cathode "Earth" 17 18 NC
LED Cathode "HD 1" 19 20 LED Cathode "LAN 1"
LED Cathode "HD 2" 21 22 LED Anode "Wrench"
LED Anode Power Button (two LEDs in parallel!) 23 24 LED Cathode "ETH 1"
LED Cathode "LAN 2" 25 26 Button Power (with HW debouncing)
GND 27 28 +5V
NC 29 30 NC
LED Cathode "ETH 2" 31 32 NC
NC 33 34 NC

The transceiver is used so that you can put the display data pins and he buttons on the same GPIOs. It's a 74F245. The display is a HDM16216L-5-LCEP.

The voltage is 5V for everything, except for the buttons. These simply pull to GND.