Bandsaw: Unterschied zwischen den Versionen
aus Metalab Wiki, dem offenen Zentrum für meta-disziplinäre Magier und technisch-kreative Enthusiasten.
Zur Navigation springenZur Suche springenReox (Diskussion | Beiträge) |
Reox (Diskussion | Beiträge) |
||
| Zeile 5: | Zeile 5: | ||
== Current Status == | == Current Status == | ||
| − | + | * REXON BS10: The green bandsaw. 1425mm x 6mm x 0,3 mm, 6 Zähne/Zoll | |
| + | ** [[Datei:BS10.pdf]] | ||
* Bergin / Clarke CBS 355: 1780mm +-3mm x 6mm, 6 TPI | * Bergin / Clarke CBS 355: 1780mm +-3mm x 6mm, 6 TPI | ||
** See https://lists.metalab.at/pipermail/cnc/2014-May/000903.html | ** See https://lists.metalab.at/pipermail/cnc/2014-May/000903.html | ||
Version vom 22. Februar 2016, 09:32 Uhr
The Metalab currently has one operational Bandsaw. The Bandsaw is from Joe since 2014-05-01_Jour_Fixe.
A bandsaw can be used to cut wood, metalls and plastics not only in straight lines, but also curved lines.
Current Status
- REXON BS10: The green bandsaw. 1425mm x 6mm x 0,3 mm, 6 Zähne/Zoll
- Bergin / Clarke CBS 355: 1780mm +-3mm x 6mm, 6 TPI
How to Operate
- Check if band is correctly tightned (Do it with caution, because the band is very sharp and can easily injure you!)
- See Repair Guide otherwise...
- Check if the band is OK
- See Repair Guide otherwise..
- Adjust the upper band holder to the correct hight (It should be right about your workpiece)
- Switch it on
- Saw
General Tips
- Do not use the bedstop (Seitenanschlag), because the cut off piece can easily lock up there and press the band aside
- A Bandsaw is a free-hand tool, mark you cut path and cut there instead of measuring on the machine
- The band swings in every direction a few parts of a mm. Consider that while you are sawing!
How to Repair
There is a good guide how to correctly setup a bandsaw here: Bandsäge einstellen (German)
