3DPrinter/Manual: Unterschied zwischen den Versionen
Zoff99 (Diskussion | Beiträge) |
Zoff99 (Diskussion | Beiträge) |
||
| Zeile 140: | Zeile 140: | ||
Updating firmware using PrusaSlicer | Updating firmware using PrusaSlicer | ||
in some cases you need to run PrusaSlicer as *root*, or the USB device will not work properly! | |||
<b>PrusaSlicer will detect the USB-connected printer even when it is powered off, but in order to upgrade the firmware, the printer has to be powered on!</b> | <b>PrusaSlicer will detect the USB-connected printer even when it is powered off, but in order to upgrade the firmware, the printer has to be powered on!</b> | ||