3DPrinter/Manual: Unterschied zwischen den Versionen
Zoff99 (Diskussion | Beiträge) |
Zoff99 (Diskussion | Beiträge) |
||
| Zeile 115: | Zeile 115: | ||
then under "Firmware 3.A.B (1.X.Y)" | then under "Firmware 3.A.B (1.X.Y)" | ||
select the download button. | select the download button. | ||
save the zip file to your computer (it will be called something like: prusa3d_fw_3_*_*_MK3_1_*_*_MMU2.zip) | |||
it does contain the firmwares for the printer and the MMU ! | |||
now unpack the zip file. | |||
and do "ls -1 prusa*en-de*hex" | |||
it will show 2 files !! | |||
one is for the older version, DO NOT FLASH this, or the printer will start to BEEP very loud | |||
until you flash the correct version. this is very annoying. | |||
use this file (with RAMBo13a in the name): | |||
"prusa3d_fw_MK25_?_?_?_????_RAMBo13a_en-de.hex" | |||
install PrusaSlicer and follow the instructions to flash the file on this page: | |||
https://manual.prusa3d.com/Guide/Upgrading+the+firmware+v1.6/66?lang=en | |||
in section: | |||
Updating firmware using PrusaSlicer | |||
do this when the printer is turned OFF !! | |||
* firmware das MMU | |||
in the same zip file from above the firmware for the MMU is called something like: | |||
"prusa3d_fw_MMU2board_1_?_?.hex" | |||
this is much harder to flash correctly, please only do this if you have successfully done it before!! | |||
== Slic3r (ausführlich) == | == Slic3r (ausführlich) == | ||
== OctoPrint (ausführlich) == | == OctoPrint (ausführlich) == | ||