Fotolab/Development Times: Unterschied zwischen den Versionen
aus Metalab Wiki, dem offenen Zentrum für meta-disziplinäre Magier und technisch-kreative Enthusiasten.
Zur Navigation springenZur Suche springenEmi (Diskussion | Beiträge) |
Emi (Diskussion | Beiträge) |
||
| Zeile 4: | Zeile 4: | ||
For the 'comments / result' column you might use the following abbreviations: | For the 'comments / result' column you might use the following abbreviations: | ||
| − | ++ | + | * very good: ++ |
| − | + | + | * good: + |
| − | 0 | + | * ok: 0 |
| − | + | * still useable: - | |
| − | -- | + | * unuseable: -- |
{| | {| | ||
Version vom 18. Oktober 2011, 14:40 Uhr
Development Times Table
This is an attempt to collect development times that users of the fotolab have tried and tested. The 'ISO' column is for the EI at which the film was exposed at. For example if you take TX-400 and expose it at EI 3200 to push it put '3200' in that colum.
For the 'comments / result' column you might use the following abbreviations:
- very good: ++
- good: +
- ok: 0
- still useable: -
- unuseable: --
| Film | ISO | Developer | Dilution | Agitation | Time | Temperature | comments / result |
|---|---|---|---|---|---|---|---|
| APX-100 | 400 | HC-110 | B | 30s then 8s per minute | 10' | 21ºC | with lomo so exposure is kinda sorta 400, film turned out nice for most of the exposures |
| Efke 50 | 50 | HC-110 | B | 30s then 10s per minute | 6'30" | 22ºC | ++ |
