Laser/How to Lazzzor: Unterschied zwischen den Versionen

← Zum vorherigen Versionsunterschied Zum nächsten Versionsunterschied →

VisuellWikitext

@@ Zeile 35: / Zeile 35: @@
 == the printer dialog ==
+(screen caps?)
-'''main tab'''
+=== main tab ===
-* Power: how much power to put into each lazzzor shot. for cutting, you want to use as little power as possible
-* Speed: how fast the lazzzor moves.<br />
-* Frequency: how many times a lazzzor shot happens. this depends greatly on the material used.
-* Job
+''Laser''
-** raster: for engraving<br />
+: '''Power''', how much power to put into each lazzzor shot. for cutting, you want to use as little power as possible
-** vector: for cutting<br />
+: '''Speed''', how fast the lazzzor moves.
-** combined: for doing both! engraving always comes first.
+: '''Frequency''', how many times a lazzzor shot happens. this depends greatly on the material used.
+<br>
+''Job''
+: '''Raster''': for engraving
+: '''Vector''': for cutting
+: '''Combined''': for doing both! Engraving always comes first.
+<br>
+''Rasterisation''
+: '''basic''': makes it look good, most of the time you'll want to use this.
+: '''3D''': good for making stuff like holes for screws.
+: '''stamp''': yeah, that's for stamps, there are also 2 additional parameters for this one.
+<br>
+''misc''
+: '''Auto focus''': important for making nice cuts, you also can do that manually (todo)
+: '''Frequency Automatic''': not tested yet! but it obviously states what it does, yes?
+: '''Vector Sorting''': algorithm which should calculate a good way to cut stuff. you probably should use a good image instead of relying on this, but most of the time it shouldn't cause any problems.
-* Rasterisation
+===user settings===
-** basic: makes it look good, most of the time youll want to use this.
-** 3D: good for making stuff like holes for screws.
-** stamp: yeah, thats for stamps, there are also 2 additional parameters for this one.
-* misc
-** Autofocus: important for making nice cuts, you also can do that manually (todo)
-** Frequency automatic: not tested yet! but it obviously states what it does, yes?
-** Vector Sorting: algorithem which should calculate a good way to cut stuff. you probably should use a good image instead of relying on this, but most of the time it shouldn't cause any problems.
-'''user settings'''
 here you can load and save settings created by other users.
-warning! this doesnt mean they are automagically the best choice,
+'''[[warning!]]''' this [[doesn't mean]] they are automagically [[the best choice]] for your job! in some cases, quite the opposite is the case and you might
-in some cases quite the opposite is the case and you might
+end up damaging your material or the lazzzor. Still, in combination with the Cheat sheet included in the manual, you can figure out if there are some reasonable settings too.
-end up damaging your material or the lazzzor. still, in combination with the cheat sheet included in the manual,
-you can figure out if there are some reasonable settings too.
-'''colormapping'''
+===color mapping===
-depending on the colors you gave your vectors, you can set individual power, speed and frequency settings for each color! might come in handy, most of the time it doesnt though.
+depending on the colors you gave your vectors, you can set individual power, speed and frequency settings for each color! might come in handy, most of the time it doesn't though.
 == the materials ==