Archiv:RepRap: Unterschied zwischen den Versionen

← Zum vorherigen Versionsunterschied Zum nächsten Versionsunterschied →

VisuellWikitext

@@ Zeile 39: / Zeile 39: @@
 === Some remarks ===
-* we are using [http://www.artofillusion.org/ AoI] to generate STL files where the units in the STL file are interpreted as mm. At the RepRap wiki they have some good tips for using [http://reprap.org/bin/view/Main/AoI AoI]. In principle we should be able to print any STL files without holes that don't have too much overhang. Even if it has overhangs you can still get good results if the overhang is like a bridge. the RepRap software doesn't care which tool you create the STL in. Exporting an STL is possible in almost any 3d program. Other things i've tried was [http://www.wings3d.com/ Wings 3d] and [http://www.blender.org/ Blender] (both open source).  I did not get far with blender, but wings3d is really usable for simple non-exact stuff.
+* we are using [http://openscad.org/ OpenSCAD] to generate STL files where the units in the STL file are interpreted as mm. In principle we should be able to print any STL files without holes that don't have too much overhang. Even if it has overhangs you can still get good results if the overhang is like a bridge. the RepRap software doesn't care which tool you create the STL in. Exporting an STL is possible in almost any 3d program. Other things i've tried was [http://www.wings3d.com/ Wings 3d] and [http://www.blender.org/ Blender] (both open source).  I did not get far with blender, but wings3d is really usable for simple non-exact stuff.
 ** the most important thing to make it printable is that is has a flat base otherwise there is no way to attach it firmly to the base plate.
 ** overhangs of more than 50 degrees might be a problem.