Mendel90: Unterschied zwischen den Versionen

@@ Zeile 18: / Zeile 18: @@
 [http://reprap.org/wiki/Printrun Printrun] ([https://github.com/kliment/Printrun GitHub repository])<br>
 [http://slic3r.org/ Slic3r]<br>
+<br>
+Bit-rate poll until end of march 2015 (please vote with your Wiki user-ID or a well-known Metalab-handle, others will be ignored):<br>
+<br>
+{| class="wikitable"
+|-
+| 115,2 kbit/s only
+| ?
+|-
+| 115,2 and 230,4 kbit/s
+| ?
+|-
+|250 kbit/s (and lower)
+| [[Benutzer:MiKa | X]]
+|}
+If you can't support any of these, sorry you will have to use the 3D-Print station, which was prepared by Amir (Thanks & Kudos to Amir!)
+Please vote until end of march, then the firmware will be fixed. I will adapt the ARDUINO-source and upload the snapshot to the Wiki.
+(This section will be updated end of march, please leave it here, don't revert the page [[Benutzer:MiKa|MiKa]] ([[Benutzer Diskussion:MiKa|Diskussion]]) 22:40, 15. Feb. 2015 (CET))
 = Resources =