Mendel90: Unterschied zwischen den Versionen
MiKa (Diskussion | Beiträge) K Zweiter Viedo: Dibond in action, printing Stanford Bunny |
Kay (Diskussion | Beiträge) add software needed for 3d printing |
||
| Zeile 28: | Zeile 28: | ||
{{#ev:youtube|y6Kc1RyHgtw}} {{#ev:youtube|wNk47pjvXbM}} | {{#ev:youtube|y6Kc1RyHgtw}} {{#ev:youtube|wNk47pjvXbM}} | ||
=== Software === | |||
* [http://www.ftdichip.com/Drivers/VCP.htm FTDI Chip VCP driver] | |||
* [http://reprap.org/wiki/Printrun Printrun] | |||
* [http://slic3r.org/ Slic3r] | |||
=== Resources === | === Resources === | ||