PCB CNC: Unterschied zwischen den Versionen
| Zeile 130: | Zeile 130: | ||
While the eagle autorouter tries to bundle wires closely together, for voronoi shaped pcbs, this is not so optimal. | While the eagle autorouter tries to bundle wires closely together, for voronoi shaped pcbs, this is not so optimal. | ||
You can still use the autorouter, however I would recommend it only on the bottom layer. I use a 12.5 mil routing grid usually, and * for bottom N/A for top. | You can still use the autorouter, however I would recommend it only on the bottom layer. I use a 12.5 mil routing grid usually, and * for bottom N/A for top. | ||
Then I move the wires around, so that the sidewards distance is maximized. This is done | Then I move the wires around, so that the sidewards distance is maximized. This is done by having arbitrary diagonals, and successively moving outer wires further outside. | ||
[[Datei:brdgoodpad.png|thumb|center|800px| Example of good (not really good, but sufficient) and bad wire placement". It is not a very good example, I will try to produce if there is time]] | [[Datei:brdgoodpad.png|thumb|center|800px| Example of good (not really good, but sufficient) and bad wire placement". It is not a very good example, I will try to produce if there is time]] | ||