PCB CNC: Unterschied zwischen den Versionen
| Zeile 127: | Zeile 127: | ||
You can still use the autorouter, however I would recommend it only on the bottom layer. I use a 12.5 mil routing grid usually, and * for bottom N/A for top. | You can still use the autorouter, however I would recommend it only on the bottom layer. I use a 12.5 mil routing grid usually, and * for bottom N/A for top. | ||
Then I move the wires around, so that the sidewards distance is maximized. | Then I move the wires around, so that the sidewards distance is maximized. | ||
[[Datei:brdgoodpad.png|Example of good (not really, but sufficient) and bad wire placement"]] | |||
[[Datei:brdgoodpad.png|800 px|Example of good (not really, but sufficient) and bad wire placement"]] | |||
==Links== | ==Links== | ||