PCB CNC: Unterschied zwischen den Versionen
Keine Bearbeitungszusammenfassung |
|||
| Zeile 22: | Zeile 22: | ||
* 5 minutes for flipping/remounting/aligning | * 5 minutes for flipping/remounting/aligning | ||
* 20 minutes for the top isolation | * 20 minutes for the top isolation | ||
* | * 2 minutes for manual overworking the board. | ||
For an arduino shield, expect about | For an arduino shield, expect about 30 minutes: | ||
* 10 minutes for preperation, mounting and setup. | * 10 minutes for preperation, mounting and setup. | ||
* 5 minutes for drilling/cutting. | * 5 minutes for drilling/cutting. | ||
| Zeile 30: | Zeile 30: | ||
* 5 minutes for flipping/remounting/aligning | * 5 minutes for flipping/remounting/aligning | ||
* 5 minutes for the top isolation | * 5 minutes for the top isolation | ||
* | * 1 minutes for manual overworking the board. | ||
=== Pros/Cons === | === Pros/Cons === | ||
Pros: | Pros: | ||
| Zeile 46: | Zeile 46: | ||
* Capacity between adjacent copper areas. | * Capacity between adjacent copper areas. | ||
* Hotter soldering is required, as there are no thermal pads. | * Hotter soldering is required, as there are no thermal pads. | ||
== Metaboard*.sh == | == Metaboard*.sh == | ||