PCB CNC: Unterschied zwischen den Versionen
| Zeile 116: | Zeile 116: | ||
Mount the board using the thin double sided tape and stick it to the flat-milled piece of wood. | Mount the board using the thin double sided tape and stick it to the flat-milled piece of wood. | ||
You want to insert a 0. | You want to insert a 0.6 mm mill-head in the Kress (a drill might break in the the sidewards cutting movement). | ||
Then you move to one location just above the mounted PCB, and set the working coordinate system using "touch off" in X and Y. For the Z, you move next to the PCB, and go tiny bit deeper than the lower board edge, and touch off at the lowest z-coordinate value, which should be -2.5 mm. For security, move up so that the mill can move freely thereafter. | Then you move to one location just above the mounted PCB, and set the working coordinate system using "touch off" in X and Y. For the Z, you move next to the PCB, and go tiny bit deeper than the lower board edge, and touch off at the lowest z-coordinate value, which should be -2.5 mm. For security, move up so that the mill can move freely thereafter. | ||