Archiv:OldLaser (2021): Unterschied zwischen den Versionen
| Zeile 94: | Zeile 94: | ||
==Cheats== | ==Cheats== | ||
* Press Stop and then Focus on the machine: Focus on the current position, rather then 50 mm diagonally shifted.. | * Focus: | ||
* XY-Off, Go: Free moving mode. OK thats not a cheat. NOW: keyboard cursor up/down moves the table up down. Cool! Also works after pressing "focus", without "go" afterwards.. | ** Press Stop and then Focus on the machine: Focus on the current position, rather then 50 mm diagonally shifted.. | ||
* Autofocus happens at the first cut/engrave position of the file. | ** XY-Off, Go: Free moving mode. OK thats not a cheat. NOW: keyboard cursor up/down moves the table up down. Cool! Also works after pressing "focus", without "go" afterwards.. | ||
* Engrave: "bottom up" is sometimes better, depends on the direction of the fumes. | ** Autofocus happens at the first cut/engrave position of the file. | ||
* Engrave: | |||
* | ** "bottom up" is sometimes better, depends on the direction of the fumes. Fumes should move away from the deep parts. | ||
* panel 3d mode | ** Stucki Rastering is nice.. Brighten=different gamma | ||
* | ** panel 3d mode: Not the position of the laser pulses is rastered, but instead the laser-power changes by the gray level. So the laser seems to be constantly on.. | ||
* Engrave speed and Power can be changed while the job is lazzoring. Not possible for vector! Press spee/powerd, and cursor up or down, go to apply | ** Engrave speed and Power can be changed while the job is lazzoring. Not possible for vector! Press spee/powerd, and cursor up or down, go to apply | ||
* | ** Plastic: Engrave whith cover foil removed. | ||
* Anodizes Aluminium: LOW POWER, High Speed, maybe multiple passes are recommended in the manual. | ** Plastic: engrave 1.5 nn out of focus=smoother surfaces. | ||
** Plastic: second pass with low power settings: removes dirt from the depths. | |||
** Plastic: can be wetted for less melting.. | |||
** Anodizes Aluminium: LOW POWER, High Speed, maybe multiple passes are recommended in the manual. | |||
** Glas: Coat Area with dish soap. Afterwards, polish with scotchbrite | |||
** Delrin: super for 3d engrave | |||
** Colorized Depths: Apply Wax to the top,engrave, color, sand top. | |||
* Homeing: | |||
** Center Engrave option in the driver-panel: where home is, e.g. move home from left top to center point, so you can engrave text on the center of a circle... | |||
* General | |||
** Multiple passes=print tab->number of copies... | |||
** The rulers can be flipped to take out the hexahedral baseplate. | |||
__NOTOC__ | __NOTOC__ | ||