PCB CNC: Unterschied zwischen den Versionen

← Zum vorherigen Versionsunterschied Zum nächsten Versionsunterschied →

VisuellWikitext

@@ Zeile 31: / Zeile 31: @@
 === Pros/Cons ===
 Pros:
- * Quite Faster than manual UV-exposing, etching and drilling.
+* Quite Faster than manual UV-exposing, etching and drilling.
- * Cool
+* Cool
- * No chemicals
+* No chemicals
- * Good for high currents, as wired are wide.
+* Good for high currents, as wired are wide.
- * Cheaper PCB material. (Same area approx 50% the price)
+* Cheaper PCB material. (Same area approx 50% the price)
- * PCBs of up to 30x20 cm. However, flatness is problematic.
+* PCBs of up to 30x20 cm. However, flatness is problematic.
 Cons:
- * If the board is not mounted completely flat, the isolation might be not deep enough, and hence there are short circuits.
+* If the board is not mounted completely flat, the isolation might be not deep enough, and hence there are short circuits.
- * Sometimes, flakes of copper short circuit neighboring copper areas. Usually at corners. A knife helps.
+* Sometimes, flakes of copper short circuit neighboring copper areas. Usually at corners. A knife helps.
- * Dust.
+* Dust.
- * Loud.
+* Loud.
- * Capacity between adjacent copper areas.
+* Capacity between adjacent copper areas.
- * Hotter soldering is required, as there are no thermal pads.
+* Hotter soldering is required, as there are no thermal pads.
- * 0805 SMD resistors work fine, although the solder locations are not visible any more. However, SMD chips are probably to small
+* 0805 SMD resistors work fine, although the solder locations are not visible any more. However, SMD chips are probably to small
 == Metaboard.sh ==