PCB CNC: Unterschied zwischen den Versionen

@@ Zeile 29: / Zeile 29: @@
 * 5 minutes for the top isolation
 * 5 minutes for manual overworking the board.
+=== Pros/Cons ===
+Pros:
+ * Quite Faster than manual UV-exposing, etching and drilling.
+ * Cool
+ * No chemicals
+ * Good for high currents, as wired are wide.
+ * Cheaper PCB material. (Same area approx 50% the price)
+ * PCBs of up to 30x20 cm. However, flatness is problematic.
+Cons:
+ * If the board is not mounted completely flat, the isolation might be not deep enough, and hence there are short circuits.
+ * Sometimes, flakes of copper short circuit neighboring copper areas. Usually at corners. A knife helps.
+ * Dust.
+ * Loud.
+ * Capacity between adjacent copper areas.
+ * Hotter soldering is required, as there are no thermal pads.
+ * 0805 SMD resistors work fine, although the solder locations are not visible any more. However, SMD chips are probably to small
 == Metaboard.sh ==