PCB CNC: Unterschied zwischen den Versionen

@@ Zeile 12: / Zeile 12: @@
 However much faster results can be obtained by milling the minimal path necessary to create the PCB-topology.
 [[Bild:visolate.png|thumb|400px| A voronoi milled PCB (left), a normally milled PCB, and a traditional PCB]]
+===Time Consumption===
+ For a complete, dense EuroPCB, expect about one hour of total time:
+* 10 minutes for preperation, mounting and setup.
+* 15 minutes for drilling/cutting.
+* 20 minutes for the isolation of the bottom layer.
+* 5 minutes for flipping/remounting/aligning
+* 20 minutes for the top isolation
+* 10 minutes for manual overworking the board.
+For an arduino shield, expect about 35 minutes:
+* 10 minutes for preperation, mounting and setup.
+* 5 minutes for drilling/cutting.
+* 5 minutes for the isolation of the bottom layer.
+* 5 minutes for flipping/remounting/aligning
+* 5 minutes for the top isolation
+* 5 minutes for manual overworking the board.
 == Metaboard.sh ==