3DPrinter/Manual: Unterschied zwischen den Versionen

← Zum vorherigen Versionsunterschied

@@ Zeile 102: / Zeile 102: @@
 == Flash new Firmware ==
+* firmware für den Prusa selber updaten/flashen
+visit: https://manual.prusa3d.com/c/English_manuals
+select "Upgrading the firmware v1.6"
+and click on that
+then visit: https://www.prusa3d.com/drivers/
+and select "Original Prusa i3 MK2.5S"
+then under "Firmware 3.A.B (1.X.Y)"
+select the download button.
+save the zip file to your computer (it will be called something like: prusa3d_fw_?_?_?_MK25S.zip)
+it does contain the firmwares for the printer! ( we don't have the MMU module installed anymore )
+now unpack the zip file.
+and do "ls -1 prusa*en-de*hex"
+it will show 2 files !!
+one is for the older version, DO NOT FLASH this, or the printer will start to BEEP very loud
+until you flash the correct version. this is very annoying.
+use this file (with RAMBo13a in the name):
+"prusa3d_fw_MK25S_?_?_?_????_RAMBo13a_en-de.hex"
+install PrusaSlicer and follow the instructions to flash the file on this page:
+https://manual.prusa3d.com/Guide/Upgrading+the+firmware+v1.6/66?lang=en
+in section:
+Updating firmware using PrusaSlicer
+in some cases you need to run PrusaSlicer as *root*, or the USB device will not work properly!
+<b>PrusaSlicer will detect the USB-connected printer even when it is powered off, but in order to upgrade the firmware, the printer has to be powered on!</b>
+* firmware das MMU
+in the same zip file from above the firmware for the MMU is called something like:
+"prusa3d_fw_MMU2board_1_?_?.hex"
+this is much harder to flash correctly, please only do this if you have successfully done it before!!
 == Slic3r (ausführlich) ==
 == OctoPrint (ausführlich) ==
+[[Kategorie:Howto]]
+[[Kategorie:3D-Druck]]