Mendel90: Unterschied zwischen den Versionen

← Zum vorherigen Versionsunterschied

VisuellWikitext

@@ Zeile 3: / Zeile 3: @@
 |image=m90.png
 |owner=Metalab
-|status=Aktiv
+|status=zerlegt
 |requirestraining=Ja
 |requiresauth=Ja
 |cost=660EUR
-|teachers=prikle, [[User:MiKa|MiKa]]
+|teachers=[[User:prikle|prikle]],[[User:Hetti|Hetti]]
 }}
-Location: [[Scannerraum]]<br>
+Location: [[WhateverLab]]<br>
 Soup: http://reprap.soup.io/<br>
 Mailinglist: https://lists.metalab.at/mailman/listinfo/3d-printing<br>
+'''Handbuch für unseren 3Dprinter:''' [[/3DPrinter-Manual]]
 = Software / prerequisites =
@@ Zeile 18: / Zeile 20: @@
 [http://reprap.org/wiki/Printrun Printrun] ([https://github.com/kliment/Printrun GitHub repository])<br>
 [http://slic3r.org/ Slic3r]<br>
-<br>
-Bit-rate poll until end of march 2015 (please vote with your Wiki user-ID or a well-known Metalab-handle, others will be ignored):<br>
-<br>
-{| class="wikitable"
-|-
-| 115,2 kbit/s only
-| ?
-|-
-| 115,2 and 230,4 kbit/s
-| ?
-|-
-|250 kbit/s (and lower)
-| [[Benutzer:MiKa | X]]
-|}
-If you can't support any of these, sorry you will have to use the 3D-Print station, which was prepared by Amir (Thanks & Kudos to Amir!)
-Please vote until end of march, then the firmware will be fixed. I will adapt the ARDUINO-source and upload the snapshot to the Wiki.
-(This section will be updated end of march, please leave it here, don't revert the page [[Benutzer:MiKa|MiKa]] ([[Benutzer Diskussion:MiKa|Diskussion]]) 22:40, 15. Feb. 2015 (CET))
 = Resources =
+Slic3r Config Bundle for Mendel90 and Witbox: [[Datei:Slic3r_config_bundle_metalab_v1.zip]]<br>
 Settings for Slic3r and Printrun: [[Datei:Slic3r1.0.1-mendel90-v1.1.2.ini.zip]]<br>
+Settings for Slic3r (Octoprint): [[Datei:Mendel90_Octoprint_v2.ini.zip]]<br>
 Lazzzor Design für Mendel90 Spule (by mika): [[Datei:Spule_für_mendel90.cdr]]<br>
@@ Zeile 86: / Zeile 70: @@
 # [[User:metaz|meta]]
 # [[User:A|A]]
+# [[User:jk|Jozef]]
 # [[User:You|You?]]