SMD-Stencils selber machen: Unterschied zwischen den Versionen
(Eine dazwischenliegende Version von einem anderen Benutzer wird nicht angezeigt) | |||
Zeile 17: | Zeile 17: | ||
** Doubleclick on Layer 31 (tCream) | ** Doubleclick on Layer 31 (tCream) | ||
** Change Fillstyle to empty | ** Change Fillstyle to empty | ||
− | + | ||
Zeile 35: | Zeile 35: | ||
* Print | * Print | ||
* Print to file (PDF) | * Print to file (PDF) | ||
+ | * Scale factor: 1 | ||
+ | |||
+ | Import the .pdf into Corel draw and you are good to go. | ||
+ | ===Alternative Steps=== | ||
− | Import the | + | # Enable the dimension |
+ | # Import the PDF to Inkscape | ||
+ | # Disable strokes for all pads! | ||
+ | # Save as SVG | ||
+ | # Import to CorelDraw | ||
+ | # Make sure the dimension fits | ||
+ | # Cut! | ||
== Ze actual cutting == | == Ze actual cutting == |
Aktuelle Version vom 5. August 2014, 17:57 Uhr
Language: | English |
---|
SMD-Stencils selber machen | |
![]() | |
Gestartet: | 01.01.2013 |
Involvierte: | User:Overflo |
Status: | active |
Beschreibung: | Howto make SMD stencils |
Shutdownprozedur: | |
Zuletzt aktualisiert: | 2014-08-05 |
This page contains Information on how to make a STENCIL for SMD paste
This Information is valid for all the electronic CAD programs but I will document how to do it in eagle.
- Open Eagle
- Open you .brd file
- Go to Layers Menu
- Disable ALL layers but Layer 31 (tCream)
- Doubleclick on Layer 31 (tCream)
- Change Fillstyle to empty
- Menu ->
- Tools ->
- DRC ->
- Masks ->
- For the CREAM insert MIN: 0 Percent: 90% Max: 4mil
- Masks ->
- DRC ->
- Tools ->
- Click Apply
Now your tCream (31) Layer contains squares/masks that are smaller than the actual pads. GOOD.
We will export this one layer as PDF now.
- Print to file (PDF)
- Scale factor: 1
Import the .pdf into Corel draw and you are good to go.
Alternative Steps
- Enable the dimension
- Import the PDF to Inkscape
- Disable strokes for all pads!
- Save as SVG
- Import to CorelDraw
- Make sure the dimension fits
- Cut!
Ze actual cutting
Use Overheadfoil that can be used with a copier (than its not PVC) i got splendid results using OHP Transparency film from NOBO
You find this in my box in the WEL shelfes on the very right, next to the whiteboard. USe freely for stencils (but nothing else)
Place the overheadfoil on a piece of plain white copier paper and cut the stencil with an outline around the PCB
Once you cut it you can remove the overheadfoil from the paper and all the little squers will stick to the paper.
Cutter settings
- Speed: 100 %
- Power: 10 %
- Hertz: Vollgas.