Iris: Unterschied zwischen den Versionen
Metaz (Diskussion | Beiträge) K |
|||
| (3 dazwischenliegende Versionen von einem anderen Benutzer werden nicht angezeigt) | |||
| Zeile 38: | Zeile 38: | ||
== Files == | == Files == | ||
Link to the .DXF for the .DXF layout of the iris: [[Datei:Iris_final.dxf]] | Link to the .DXF for the .DXF layout of the iris: [[Datei:Iris_final.dxf]] | ||
| + | |||
| + | this file is released under [http://creativecommons.org/licenses/by-nc/3.0/ Attribution - Non-Commercial - Creative Commons] license | ||
== Videos == | == Videos == | ||
| Zeile 55: | Zeile 57: | ||
== Links == | == Links == | ||
* SVN with current software https://whatever.metalab.at/projects/Iris/ | * SVN with current software https://whatever.metalab.at/projects/Iris/ | ||
| + | * Inspiration: http://www.talkshopbot.com/forum/showthread.php?t=795 Thanks to Chris Schaie for his very friendly feedback and coming up with a very similar design first | ||
| + | |||
| + | |||
| + | == TODOs == | ||
| + | * New welcome video | ||
| + | * more "hello" wav samples | ||
| + | * add motion sensor (ultrasonic) to trigger the welcome sequence, too many people ring the doorbell to see this ;) | ||
[[Kategorie:Vorraum]] | [[Kategorie:Vorraum]] | ||
[[Kategorie:English]] | [[Kategorie:English]] | ||
Aktuelle Version vom 28. September 2010, 16:02 Uhr
The IRIS project
- is an automated welcoming system
- consists of an arduino, a waveshield, some lasercutted parts, a digital photoframe, a stepper motor, a stepper motor controller board
every time a visitor rings the door bell the uv light is turned on, the shiney plexi parts start to glow and the iris opens.
then the backlight of the fotoframe is turned on and the visitor sees whatever video is currently displayed (can not be controlled)
a short welcoming audio sample is played over the waveshield and after ~15 seconds the iris closes again and the backlight is turned off
Initalization
as the photoframe would not start videos from the SDcard automatically the enclosure of the fotoframe was opened and the buttons needed to e pressed to start a video where bound to pins on the arduino using optocouplers from the Bauteilsortiment.
when the machine is turned on it opens the iris slowly till it hits the endstop refernce point. (minidipswitch).
after a timeout of ~15 seconds the photoframe has booted and the microcontroller pushes the buttons to navigate triugh the menu and start the first found video on the SD card ENTER,ENTER,LEFT,LEFT,LEFT,ENTER,ENTER :)
then we turn off the background light (MOSFET) and close the iris (we are still at the endstop position)
from there it takes 140 steps in the other direction to close the iris again.
Who
Files
Link to the .DXF for the .DXF layout of the iris: Datei:Iris final.dxf
this file is released under Attribution - Non-Commercial - Creative Commons license
Videos
Photos
Links
- SVN with current software https://whatever.metalab.at/projects/Iris/
- Inspiration: http://www.talkshopbot.com/forum/showthread.php?t=795 Thanks to Chris Schaie for his very friendly feedback and coming up with a very similar design first
TODOs
- New welcome video
- more "hello" wav samples
- add motion sensor (ultrasonic) to trigger the welcome sequence, too many people ring the doorbell to see this ;)
