LibRemote: Unterschied zwischen den Versionen

Zeile 34:

The computer's IP is [http://10.20.30.111 <code>10.20.30.111</code>] and the DNS name is [http://libremote.lan <code>libremote.lan</code>].

To use it, you have to power on the HDMI-Switch and connected devices. To do this, locate the "BibAudio" switch on the [http://smart.metalab.at/lovelace/0 SmartLab Home dashboard] and make sure that it's activated. Also check if the LibRemote PC is active as the Input Device on the HDMI-Switch. It is Input 5

To use it, you have to power on the HDMI-Switch and connected devices. To do this, locate the "BibAudio" switch on the [http://smart.metalab.at/lovelace/0 SmartLab Home dashboard] and make sure that it's activated. Also check if the LibRemote PC is active as the Input Device on the HDMI-Switch. It is Input 5.

The HDMI-Switch and the computer are located over the printer to the left when entering the library.

Usually the computer is turned off. Wake on Lan ([https://en.wikipedia.org/wiki/Wake-on-LAN WoL]) is enabled and you can boot the PC via Magic packet. Various (CLI) tools exist, see [https://wiki.archlinux.org/title/Wake-on-LAN#Trigger_a_wake_up Trigger Wake up on Arch Wiki]

MAC Address for WoL: <code>e4:e7:49:47:92:77</code>

MAC Address for WoL: <code>e4:e7:49:47:92:77</code>

Alternatively, you can power the computer on manually with the small powerbutton on the front, you probably need a ladder, to reach the computer.

To remote control the computer, connect to '''http://10.20.30.111'''. The login is '''metalab/metalab'''.