Laser/Lazzzorauth: Unterschied zwischen den Versionen

Version vom 2. November 2012, 05:30 Uhr

Consists of:

- Raspberry Pi
- Arduino
- 16x2 LCD
- OneWire (iButton suport)
- 3 Leds for status indication
- 1 Button
- a 6-Port Network Switch

2012-07-15-wheezy

Node.js

Arduino code

Hardware documentation

Breadboard aufbau (made with fritzing)

The hall effect sensor + Preamp

There is a hall effect sensor placed right over the valve of the airassist.

This valve is opened to enable a static airflow as soon as a laserjob starts and is disabled when the job ends.

Software documentation

this is partially wrong and needs correction

Arduino SENDS:

Code	Parameter	Expected reply	What does it mean	Example
I	<iButton ID>	A, N	IButton scanned	I:33-000000000000
X	NONE	O	Lazzzor shutdown button hit (eXit)	X
P	NONE	P	Ping! /Heartbeat	P

Raspberry sends:

Code	Parameter	Expected reply	What does it mean	Example
A	<username>	NONE	Authenticated	A:OVERFLO
N	NONE	NONE	Not authenticated (invalid Button)	N
O	NONE	NONE	Off (in response to X)	O
P	NONE	NONE	Heartbeat / PING	P
E	<Error>	NONE	Some Error occured	E:Network down!

@@ Zeile 23: / Zeile 23: @@
 Hardware documentation
 [[Datei:Lazzzorauth_bb_small.png|200px|thumb|left|Breadboard aufbau (made with fritzing)]]
-- TODO: needs doku
+[[Datei:Lazzzorauth_sensor.jpg|200px|thumb|left|The hall effect sensor + Preamp]]
+There is a hall effect sensor placed right over the valve of the airassist.
+This valve is opened to enable a static airflow as soon as a laserjob starts and is disabled when the job ends.