Witbox: Unterschied zwischen den Versionen

← Zum vorherigen Versionsunterschied Zum nächsten Versionsunterschied →

VisuellWikitext

@@ Zeile 34: / Zeile 34: @@
 ===How to use it===
 '''Calibration (before every job @ metalab)'''
-- There is a calibration sheet inside the witbox.
-- Calibration is simple. Just follow the instructions on the menu.
+* There is a calibration sheet inside the witbox.
-- Configuration -> Level plate
+* Calibration is simple. Just follow the instructions on the menu.
+* Configuration -> Level plate
 '''Load / Change Filament if neccessary  - Careful not to entangle the filament!!'''
-- To cahnge or unload the filament select the matching option from the menu
+* To change or unload the filament select the matching option from the menu
-- very gently apply some pull to the filament and you will feel that the filament is actually pulled for extraction first and after some seconds it is ejected
+* very gently apply some pull to the filament and you will feel that the filament is actually pulled for extraction first and after some seconds it is ejected
-- Once the filament is eject apply some more pullign force
+* Once the filament is eject apply some more pullign force
-- when the filament comes loose pull sharply and remove the filament from the tube completely (also any long debris that might hang off the filament needs to get out)
+* when the filament comes loose pull sharply and remove the filament from the tube completely (also any long debris that might hang off the filament needs to get out)
 '''Save your .gcode to the SD card'''
-- Start cura
+* Start cura
-- Import .stl
+* Import .stl
-- Save to SD
+* Save to SD
-- Done.
+* Done.
 '''Start job from menu'''
-- Select "Print from SD"
+* Select "Print from SD"
-- Select your job
+* Select your job
-- Push  dialing wheel- > job starts
+* Push  dialing wheel- > job starts