Witbox: Unterschied zwischen den Versionen

@@ Zeile 6: / Zeile 6: @@
 |status=Aktiv
 |requirestraining=Ja
-|requiresauth=[[Druckerkammerl|Ja]]   ???
+|requiresauth=[[Scanner_Raum|Ja]]   ???
-|cost=????
+|cost=0.10 euro / gram
-|teachers={{Druckermenschen}} ???
 }}
 __TOC__
@@ Zeile 32: / Zeile 31: @@
 Careful not to entangle the filament!!
+===Wisdom Tables ===
+These settings have been tested and worked fine.  {{Yes}}
+{| class="wikitable"
+!width="200"| MATERIAL !!width="50"| Layer height !! width="50"| Temperature !! width="100"|Speed !! width="100"|Who tried this !! width="100"|  Notes
+|-
+| PLA Neon Green || 0.1mm ||80mm/sec || 210C || [[Benutzer:Overflo|overflo]] || Good.
+|-
+| PLA WHITE (no mame big spool) || 0.1mm ||80mm/sec || 210C || [[Benutzer:Overflo|overflo]] || Looks better at higher temperature
+|-
+| PLA Black bq || 0.1mm ||80mm/sec || 210C || [[Benutzer:Overflo|overflo]] || Good.
+|-
+| PLA transparent bq|| 0.1mm ||80mm/sec || 210C || [[Benutzer:Overflo|overflo]] || Good.
+|-
+| PLA purple noname (3dee.at)|| 0.1mm ||80mm/sec || 210C || [[Benutzer:Overflo|overflo]] || Good.
+|-
+|}
+These settings caused some problems  {{No}}
+{| class="wikitable"
+!width="200"| MATERIAL !!width="50"| Layer height !! width="50"| Temperature (°C)  !! width="100"|Speed !! width="100"|Who tried this !! width="100"|  Notes
+|-
+| WHAT?  || LAYER? ||SPEED||  TEMPERATURE || [[Benutzer:you|you]] || COMMENTS
+|-
+|}
 ===TODOs===