Mendel90: Unterschied zwischen den Versionen

@@ Zeile 7: / Zeile 7: @@
 |requiresauth=Ja
 |cost=660EUR
-|teachers=[[User:prikle|prikle]], [[User:MiKa|MiKa]]
+|teachers=[[User:prikle|prikle]]
 }}
@@ Zeile 20: / Zeile 20: @@
 [http://reprap.org/wiki/Printrun Printrun] ([https://github.com/kliment/Printrun GitHub repository])<br>
 [http://slic3r.org/ Slic3r]<br>
-<br>
-Bit-rate poll until end of march 2015 (please vote with your Wiki user-ID or a well-known Metalab-handle, others will be ignored):<br>
-<br>
-{| class="wikitable"
-|-
-| 115,2 kbit/s only
-| ?
-|-
-| 115,2 and 230,4 kbit/s
-| ?
-|-
-|250 kbit/s (and lower)
-| [[Benutzer:MiKa | X]]
-|}
-If you can't support any of these, sorry you will have to use the 3D-Print station, which was prepared by Amir (Thanks & Kudos to Amir!)
-Please vote until end of march, then the firmware will be fixed. I will adapt the ARDUINO-source and upload the snapshot to the Wiki.
-(This section will be updated end of march, please leave it here, don't revert the page [[Benutzer:MiKa|MiKa]] ([[Benutzer Diskussion:MiKa|Diskussion]]) 22:40, 15. Feb. 2015 (CET))
 = Resources =