GoCNC: Unterschied zwischen den Versionen
Reox (Diskussion | Beiträge) Keine Bearbeitungszusammenfassung |
Reox (Diskussion | Beiträge) |
||
| Zeile 22: | Zeile 22: | ||
* Maximum Speed: around 1000mm/min | * Maximum Speed: around 1000mm/min | ||
* For use with Dremel or Proxxon Device as spindle | * For use with Dremel or Proxxon Device as spindle | ||
* It uses M10 threaded rods, which are quite bad... | * It uses M10 threaded rods, which are quite bad... | ||
* You can not put too much torque on the screws that hold the Z axis on the X axis - therefore the axis is not very stable. | |||
** If you fix the axis, the axis will be locked! | |||
== Configuration == | == Configuration == | ||